Installation and User Guide
Model No: EVCC-DP-101-SP50
Setup - Connect via WiFi
Now that the charger (EVCC) has been added, it's time to ensure it's connected to the CSMS and able send and receive messages. On the Chargers page, if the charger is displaying an offline status (gray circular icon), it will need to be connected to the Internet before any charging can take place.
If the charger is connected via Ethernet, the status icon should be green indicating it's on-line. If it's gray, the device will need to be connected via the WiFi provisioning process.
There are a few requirements to connect the EVCC via WiFi:
- You'll need the Android or iPhone AmpedUp! Networks app. You will not be able to provision the WiFi using a browser.
- The Bluetooth radio will need to be enabled on your mobile device.
- You'll need to be about 15 feet or closer to the EVCC during the WiFi provisioning process.
- There must be a strong WiFi signal near the EVCC.
- You'll need the access credentials of the WiFi network to which the EVCC will be connected.
Follow These Steps
Follow the steps below to connect the charger via the WiFi provisioning process.
1
From the Chargers screen of the AmpedUp! Networks CSO app, press the ellipse icon on the right side of the charger to connect. Press the Network icon in the tool bar.
Note: If the EVCC is already online, the Network icon will not be displayed.
Note: If the EVCC is already online, the Network icon will not be displayed.
2
Once the Network icon is selected, the Set up WiFi screen will be displayed. The app will search for, via Bluetooth, the EVCC to connect to.
3
Once located, the screen will display a WiFi Access Point (WAP) list and the WiFi password entry field.
Choose the appropriate WAP and enter the password of the selected WiFi access point, then choose the Connect button.
Choose the appropriate WAP and enter the password of the selected WiFi access point, then choose the Connect button.
4
In a few seconds, the EVCC should return a "Successfully Connected" message and connect to the WiFi and then to the Internet. The process will also return the IP address of the EVCC and access to the EVCC's firmware administration interface. Keep note of the IP address for access later.
Note: You can select the IP address link to open the administrative interface to the EVCC firmware. Or, you can access the interface via any browser on the WiFi network by entering the IP address in the address bar of the browser (ie: "http://<ipaddress>").
The default username and password to the EVCC firmware is:
U: system_owner
P: YX4EPCk9x
Note: You can select the IP address link to open the administrative interface to the EVCC firmware. Or, you can access the interface via any browser on the WiFi network by entering the IP address in the address bar of the browser (ie: "http://<ipaddress>").
The default username and password to the EVCC firmware is:
U: system_owner
P: YX4EPCk9x
5
Press the Done button to jump to the Edit Charger Properties screen. It may be necessary to enable the charger to make it available. You can do so by pressing the Enable Charger toggle button.
Be sure to press the Save button. You'll then be returned to the Chargers screen.
Be sure to press the Save button. You'll then be returned to the Chargers screen.
6
Now, the charger's status icon should display green for "online".
